This is just the first guess. I'll try two openings next. One on the
left on the cowl and one on the bottom of the cowl.
If the PSRU is integrated into the front cover that will act as a
huge heat sink. A few fins here and there might be advisable.
------------------------------------------------------
Here it is with a 10 inch spinner. Two cooling baffles. One under
the spinner and one on the upper left from the pilots point of view.
Much better than one opening. These are 4 inch diameter openings.
This is going to make one heck of a very low cost LSA engine.
I think we should sell it at the same price as a Rotax 912.
Paul Lamar
The heat sink material could be bought in full length, cut to the
length needed, machined with bolt flanges on the side to allow the
heatsink to be bolted to the end plate edges. No fasteners in the
rotor housing. Just an option.
Steve Carlisle
You need a good clamping force on the heat sinks so studs welded to
the rotor housing are advisable.
With the exhaust and the intake mounted down we could go forward with
the intake and use a side draft Rotec/Eillison carb under the front
of the engine.
Paul Lamar
For a little extra cooling, duct air through the wedge formed by the
heat sink end fins and place additional heat sink on the rear end plate.
Chris Cosman
Excellent idea Chris. That will bring some cooling air back around the
engine to cool the back cover. Very very good. That will give me some
guidances on the direction of the fins on the end housing. I think I
will bolt on a small heat sink on the end housing as well. Lower cost
and the fins are thinner and closer together than what one could make
with an NC Mill.
Paul Lamar
The Rotary Engine free News Letter. Powered by Linux. If you want off
the list PLEASE let me know and I will remove you. ACRE NL web
site.
http://www.rotaryeng.net You Tube
http://tinyurl.com/beqqxas
Copyright 1998-2016 All world wide rights reserved.