Subject: air cooling baffling for un symmetrical air cooled Mazda
From: paul lamar
Date: 11/1/2016, 5:08 PM
To: A10-Me-Earthlink




  This is just the first guess. I'll try two openings next. One on the
  left on the cowl  and one on the bottom of the cowl.

  If the PSRU is integrated into the front cover that will act as a
  huge heat sink. A few fins here and there might be advisable.


  ------------------------------------------------------

  Here it is with a 10 inch spinner. Two cooling baffles. One under the
  spinner and one on the upper left from the pilots point of view. Much
  better than one opening. These are 4 inch diameter openings.

  This is going to make one heck of a very low cost  LSA engine.

  I think we should sell it at the same price as a Rotax 912.


  Paul Lamar



  The heat sink material could be bought in full length, cut to the
  length needed,  machined with bolt flanges on the side to allow the
  heatsink to be bolted to the end plate edges. No fasteners in the
  rotor housing. Just an option.

  Steve Carlisle

You need a good clamping force on the heat sinks so studs welded to
the rotor housing are advisable.

With the exhaust and the intake mounted down we could go forward
with the intake and use a side draft Rotec/Eillison  carb under the
front of the engine.

Paul Lamar


Hi Paul
Do the drawings depict a pusher or tractor configuration ?
How would you contemplate welding the studs to the housing ? Electrical resistance but weld, Tig etc
Regards

Bill McDonald

Tig, gas or braze :-) Anything will work. Just machine a small clearance depression
in the back of the  heat sink around the stud hole to accommodate the weld area.

Paul Lamar



  The Rotary Engine free News Letter. Powered by Linux. If you want
  off the list PLEASE let me know and I will remove  you.  ACRE NL web
  site. http://www.rotaryeng.net <http://www.rotaryeng.net/>You Tube http://tinyurl.com/beqqxas
  Copyright 1998-2016 All world wide rights reserved.