Subject: Cutting the ring gear down. Building your own gear box.
From: paul lamar
Date: 11/13/2016, 2:40 PM
To: A10-Me-Earthlink


 This is the poor mans tool post grinder.
 It is a 6 inch 1/3 HP $45 dollar bench grinder
 from harbor freight.

 Makes a super smooth cut but it takes about
 2 hours to get off the unneeded 3/4 inch
 on the ring gear. You will save a pound.

 Cutting it with a carbide tool creates a fire.

 That ring gear is super hard.

 If you flame cut it off it will soften it.

 A laser or water jet might do it but I haven't tried
 that yet and it could be expensive.

 It will also work to get rid of the unneeded teeth
 on the sun gear.

 Paul Lamar


Hi Paul,
Glad to see the ways covered...if you have a 4" grinder about put a cut off wheel on it and attach it to the cross slide. The cut should take only minutes and maybe burn up 2 wheels. The pictured grinder will finish up nicely. As you have already done. Way to get er done.
Michael Nash


That sounds like it will work. I'll try that on the next one. What amazes me the part barely
gets above room temperature.

In this picture you can see the dust particles curving to go in to the vacuum hose :-)

the finish is suburb.



 The Rotary Engine free News Letter. Powered by Linux. If you want off
 the list PLEASE let me know and I will remove  you.  ACRE NL web
 site. http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
 Copyright 1998-2016 All world wide rights reserved.