Subject: unsymmetrical engine or air cooled rotary
From: paul lamar
Date: 11/13/2016, 5:19 PM
To: A10-Me-Earthlink


Instead of casting a steel or iron rotor housing would it not be easier
to wire edm one ?

O r if using the steel liner your picture 20121110_170021 6/11/2015 wire
edm from alumiium plate complete with cooling fins,

This liner could allow twin spark plugs  thus allowing dual ignition

if the inner profile matched the external of the liner the aluminium
could be heat shrunk to fit

On another post there was a four rotor which seemed to be air cooled
but without cooling fins or was this a development by Tony Taghiem

Peter Whitehead

Wire EDM would be cost effective on the raw billet steel rotor housing I think.
Just to get rid of the mass of unneeded steel.

I am not sure of the finish quality however. The final finish, after heat treating
I suspect, would have to be done with a NC mill and a grinding tool.

The EDM air cooling fins are totally out of the question as the EDM cost would be astronomical.
It would take too long and time is money.

The real cost breakthrough here is using high fin density, mass produced,
extruded low cost aluminum heat sinks. These fins are on the order of 1/16th" thick
and on a 1/8th" inch pitch. The OMC engineers would have given their right arm
for that fin density and the power of the  air cooled OMC snow mobile engine
would be up by 150%.

Probably a patentable idea but I am giving it to the news letter subscribers
for nothing :-)  Its free. Just like the welded P-port now viewed by 170,000 people
on You Tube. God only know how many people are now welding their
rotary engine  p-ports to the steel liner. :-) We have pictures of it being done
in the Netherlands.

Paul Lamar

The Rotary Engine free News Letter. Powered by Linux. If you want off
the list PLEASE let me know and I will remove  you.  ACRE NL web
site. http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
Copyright 1998-2016 All world wide rights reserved.