Subject: Oil injector hole pressure tap fittings, I need two of them, how do I get them?
From: paul lamar
Date: 11/25/2016, 6:18 PM
To: A10-Me-Earthlink



   Oil injector hole pressure tap fittings, I need two of them, how do I get them?

   Inline image 1

   --
   Berkley Thompson

   I am out right at the moment and it is real expensive to make just 2 on an NC lathe.
   The biz is starting to pick up again but it will be six months or a year before
   it is fiscally possible to make a bunch more on an NC lathe.

   I can hand make two of them for you for $25 dollars each.

   Go on the Lamar Instruments web site and make a $50 donation
   to the time to climb project.

   http://lamarinstruments.com/

   Send me your mailing address.

   Add $5 for shipping.

   Paul Lamar


   What is the thread? Could you use a short cap screw of say 1/2" length and drill a hole in the
   center and Siler solder or braze a short tube that has a small lip on it?
   Dale Davies

   10 MM 1.0

   Paul Lamar

   The Rotary Engine free News Letter. Powered by Linux. If you want off
   the list PLEASE let me know and I will remove  you.  ACRE NL web
   site. http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
   Copyright 1998-2016 All world wide rights reserved.