Oil injector hole pressure tap fittings, I need two of them, how do
I get them?

Inline image 1

--
Berkley Thompson

I am out right at the moment and it is real expensive to make just
2 on an NC lathe.
The biz is starting to pick up again but it will be six months or a
year before
it is fiscally possible to make a bunch more on an NC lathe.

I can hand make two of them for you for $25 dollars each.

Go on the Lamar Instruments web site and make a $50 donation
to the time to climb project.

http://lamarinstruments.com/

Send me your mailing address.

Add $5 for shipping.

Paul Lamar


What is the thread? Could you use a short cap screw of say 1/2"
length and drill a hole in the
center and Siler solder or braze a short tube that has a small lip
on it?
Dale Davies

10 MM 1.0

Paul Lamar

Paul and All,

Double check the thread for the oil injector hole fittings.........I have used short 86-91 RX7 torque converter
to flex-plate bolts to plug these holes........If I remember correctly they are 10 mm x  1.25 thread.......FWIW

Kelly Troyer

I think you screwed up the threads :-) A metric 1.0 is real close to a metric 1.25
It is easy to screw the wrong metric thread into aluminum :-)

Paul Lamar


The Rotary Engine free News Letter. Powered by Linux. If you want off
the list PLEASE let me know and I will remove  you.  ACRE NL web
site. http://www.rotaryeng.net <http://www.rotaryeng.net/>You Tube http://tinyurl.com/beqqxas
Copyright 1998-2016 All world wide rights reserved.