I came across this picture in a design guide brochure for a 3D
printing service (Xometry). Immediately recognized the trochoid shape
with cooling chambers. I was going to inquire about the cost of the part
and whether dissimiliar metals can be combined in one cohesive part.
Anyone in the rotary group recognize it as their own?
Daniel Tyler
Inline image 1
Could they be making the part in wax or low temp plastic then
casting the housing? Wouldn't the housing be stronger if ot were cut
from billet? (Using a water jet cutter to avoid heating the metal ?
Rob Miller
Paul, Rob,
I have done a lot of research on the DMLS process. This is not wax!
This is directly FUSED metal. The resulting solid is generally as good
as billet material. This additive process uses the laser to melt the
layers together. many exotic materials are available. The earliest use I
saw of this technology was it make new shape jet engine compressor
blades. This is a very highly stressed part and the DMLS process was
making a nearly finished shape. Very little post machining. The price
varies based on how exact you want the part and the finish. If you want
a very good surface the layers must be very thin and the laser time will
be high. If you can deal with a fairly rough surface say +-.010-.015 it
is considerably cheaper. That rotor housing would require inside
finishing and coating, but the outside could be left as is. The water
passages might even benefit by having more surface area.
Bill Jepson
Ok that's cool what I meant by wax was the most wax casting process
where the part is made out of wax or low temp plastic and a mold is made
and the metal poured in melting and displacing the medium and making a
cast metal part but the process you described sounds good
Rob Miller
The Rotary Engine free News Letter. Powered by Linux. If you
want off
the list PLEASE let me know and I will remove you. ACRE NL web
site.
http://www.rotaryeng.net You Tube
http://tinyurl.com/beqqxas
Copyright 1998-2016 All world wide rights reserved.