I had some steel rectangular tubing I wanted to form into
a part to hold dial indicators on my lathe. The band saw was too slow and some
cuts were not possible on a band saw. I discovered the solution.

 I put a warn down to (10 inches)  14 inch friction saw blade and put in in the table saw.
Worked like a charm and  it was almost as  fast as a hot knife through butter:-)

It is wonderful and great for cutting sheet steel up to about 1/8th or maybe 3/16th inch
thick. Much cleaner and much faster and much cheaper than a cutting torch.

Paul Lamar

The Rotary Engine free News Letter. Powered by Linux. If you want off
the list PLEASE let me know and I will remove  you.  ACRE NL web
site. http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
Copyright 1998-2016 All world wide rights reserved.