I had some steel rectangular tubing I wanted to form into a part to
hold dial indicators on my lathe. The band saw was too slow and some
 cuts were not possible on a band saw. I discovered the solution.

I put a warn down to (10 inches)  14 inch friction saw blade and put
 in in the table saw. Worked like a charm and  it was almost as
fast as a hot knife through butter:-)

It is wonderful and great for cutting sheet steel up to about 1/8th
or maybe 3/16th inch thick. Much cleaner and much faster and much
cheaper than a cutting torch.

Paul Lamar

I use a metal cutting blade in my table saw, I have one set up just
for metal. I can't remember the manufacturer name, the blades are
about $50 for a 10 in but they are made for his purpose and work
great. I have cut up to 1.25 6061T6 and .250 4130 with them. Just
watch your feed rate and use cutting lube.

No scoring needed.

David Mikesell


I use a carbide blade for cutting aluminum on the table saw.
That works great.

Never tried it on steel. That scares me :-)

Paul Lamar

The Rotary Engine free News Letter. Powered by Linux. If you want off
the list PLEASE let me know and I will remove  you.  ACRE NL web
site. http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
Copyright 1998-2016 All world wide rights reserved.