My Morse taper gave out when drilling brass on my CC lathe. The drill
digs into the brass and then the taper slips. It took me hours to drill
a 2 inch hole in the 3/4 thick aluminum bar shown keeping the taper
chuck from rotating.
It holds when drilling aluminum or steel.
The reason for the brass interior part was because aluminum would
generate yellow snot when flowing methanol.
These injector holders are high precision. The adjustable 3 jaw chuck on
my CC lathe was under a 1/2 thou run out. This design would not be
possible with out that.
Basically it is built around 37 degree flare fitting AN-6 to 1/4 inch
pipe steel adapter from McMaster Carr. Under $3 each.
And 5/8 diameter brass rod insert. That had to be machined down as the
diameter tolerance was all over the lot.
In terms of hours of engineering, design and machining at $50 an hour
they are worth well over $500 each :-)
The tiny drilled head SS 6-32 screws are also from MacMaster.
This was a precision operation as well as the hole depth for the screws
was limited to exactly .2 inches or one would have a
150 psi leak. There are only about 6 threads in the hole.
Once they are safety wired they just act as retaining pins.
The mechanic better go easy with the screw driver :-)
The .040 aluminum straps holding the whole works together are not shown.
They will be tig welded to the large intake tubes.
This 200 pound 2 rotor engine is generating 650 HP with only four
injectors. PAC in Oz used eight for some strange reason. Maybe they have
not heard about the Bosch 2000 injectors :-) Maybe that was for a 4 rotor.
Paul Lamar
Hi Paul,
The best way to drill brass is the same as the way to drill perspex
(acrylic). Take the leading edge off the spiral flute of the drill, thus
effectively "blunting" it, this will stop it from biting in and require
a little "force" to drill through which will keep the drill or chuck
firmly in the morse taper.
Cheers Chris Hoskins.
Thanks Chris
Paul Lamar ...Merry Christmas
The Rotary Engine free News Letter. Powered by Linux. If you want off
the list PLEASE let me know and I will remove you. ACRE NL web
site.
http://www.rotaryeng.net You Tube
http://tinyurl.com/beqqxas
Copyright 1998-2016 All world wide rights reserved.