Subject: 650 HP TTC injector holders are done.
From: paul lamar
Date: 12/17/2016, 2:19 PM
To: A10-Me-Earthlink


My Morse taper gave out when drilling  brass  on my CC lathe. The
drill digs into the brass and then the taper slips. It took me hours
to drill a 2 inch hole in the 3/4 thick aluminum bar shown keeping
the taper chuck from rotating. It holds when drilling  aluminum or
steel.

The reason for the brass interior part was because aluminum would
generate yellow snot when flowing methanol.

These injector holders are high precision. The adjustable 3 jaw
chuck on my CC lathe was under a 1/2 thou run out. This design would
not be possible with out that.

Basically it is built around 37 degree flare fitting AN-6  to 1/4
inch pipe steel adapter from McMaster Carr. Under $3 each. And 5/8
diameter brass rod insert. That had to be machined down as the
diameter tolerance was all over the lot.

In terms of hours of engineering, design and machining at $50 an
hour they are worth well over $500 each :-)

The tiny drilled head SS 6-32 screws are also from MacMaster. This
was a precision operation as well as the hole depth for the screws
was limited to exactly .2 inches or one would have a 150 psi leak.
There are only about 6 threads in the hole. Once they are safety
wired they just act as retaining pins. The mechanic better go easy
with the screw driver :-)

The .040 aluminum straps holding the whole works together are not
shown. They will be tig welded to the large intake tubes.

This 200 pound 2 rotor engine is generating  650 HP with only four
injectors. PAC in Oz used eight for some strange reason. Maybe they
have not heard about the Bosch 2000 injectors :-) Maybe that was for
a 4 rotor.

Paul Lamar

Paul, How is the brass insert sealed to the steel AN-6 fitting
??........."O" ring ??......

Kelly Troyer

Coated with RTV and pressed in with a six ton press.


Paul Lamar


Paul, Hate to be a Naysayer but what does Methanol do to RTV
?...........When Randy was building my "P" ports he at first was
depending on the press fit between the stainless tube and a aluminum
collar to seal for coolant (on the advice of his machinist who said
this type of fit was used on the Navy F-14).........The aluminum was
then welded to the exterior of the housing but it leaked under
pressure...........We ended up with his version of  your "O" ringed
exterior plates and "JB" weld to seal the coolant cavity.........

Kelly Troyer

Good point. I soaked some in methanol and It did not seem to bother it.
I know gasoline is a no no with silicon rubber. The joint is very tight with
a lot of area. The brass was machine to fit the drill angle.

In your case the rate of expansion of the aluminum is higher than SS
so when he welded it that opened up a gap.

That is the trouble with people copying  my designs. They must do it precisely.
Make no changes :-) I have reasons for everything. That is not to say I am always  perfect
by a long shot :-)

Paul Lamar Merry Christmas


The Rotary Engine free News Letter. Powered by Linux. If you want off
the list PLEASE let me know and I will remove  you.  ACRE NL web
site. http://www.rotaryeng.net <http://www.rotaryeng.net/You Tube
http://tinyurl.com/beqqxas Copyright 1998-2016 All world wide rights
reserved.