Subject: 650 HP TTC injector holders are done.
From: paul lamar
Date: 12/18/2016, 3:02 PM
To: A10-Me-Earthlink


My Morse taper gave out when drilling  brass  on my CC lathe. The
drill digs into the brass and then the taper slips. It took me hours
 to drill a 2 inch hole in the 3/4 thick aluminum bar shown keeping
the taper chuck from rotating. It holds when drilling  aluminum or
steel.

The reason for the brass interior part was because aluminum would
generate yellow snot when flowing methanol.

These injector holders are high precision. The adjustable 3 jaw chuck
 on my CC lathe was under a 1/2 thou run out. This design would not
be possible with out that.

Basically it is built around 37 degree flare fitting AN-6  to 1/4
inch pipe steel adapter from McMaster Carr. Under $3 each. And 5/8
diameter brass rod insert. That had to be machined down as the
diameter tolerance was all over the lot.

In terms of hours of engineering, design and machining at $50 an hour
 they are worth well over $500 each :-)

The tiny drilled head SS 6-32 screws are also from MacMaster. This
was a precision operation as well as the hole depth for the screws
was limited to exactly .2 inches or one would have a 150 psi leak.
There are only about 6 threads in the hole. Once they are safety
wired they just act as retaining pins. The mechanic better go easy
with the screw driver :-)

The .040 aluminum straps holding the whole works together are not
shown. They will be tig welded to the large intake tubes.

This 200 pound 2 rotor engine is generating  650 HP with only four
injectors. PAC in Oz used eight for some strange reason. Maybe they
have not heard about the Bosch 2000 injectors :-) Maybe that was for
a 4 rotor.

Paul Lamar


Hi Paul, The best way to drill brass is the same as the way to drill
 perspex (acrylic). Take the leading edge off the spiral flute of the
 drill, thus effectively "blunting" it, this will stop it from biting
 in and require a little "force" to drill through which will keep the
 drill or chuck firmly in the morse taper. Cheers Chris Hoskins.

Thanks Chris

Paul Lamar ...Merry Christmas Hi Paul,

About 60 yrs ago when I was serving a 10,000 Hour apprenticeship we
were shifted to a different type of workshop every 1,000 hours and one
of them was the brass workshop where all we were taught to work with was
brass.  No twist drills were used and we used to make our own drills out
of flat  bar tool steel about1/8" thick . The drill stem was from round
steel bar and a slot milled in one end and thwe tool steel tip was
"easyflo" joined to the stem the tip was angled like a std. drill but
the cutting edge was untouched but there was a slight angle relief on
the trailing edge.  The whole aim of the drill to produce chips. This
meant that the drill would never catch and the speed of drilling could
be increased.  We also did the same thing to make profile shapes with
the flat bar tool steel to make lathe tools  to produce knobs etc. with
a single cut.
Colin Dale


The Rotary Engine free News Letter. Powered by Linux. If you want
off the list PLEASE let me know and I will remove  you.  ACRE NL web
site. http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
Copyright 1998-2016 All world wide rights reserved.