Subject: Oil injector hole pressure tap. $20 each
From: paul lamar
Date: 12/29/2016, 12:41 PM
To: A10-Me-Earthlink



Paul:

I need two of these - could you please respond and let me know how I can purchase these and please include the total with shipping!

Thank you so very much!
Berkley Thompson

I am out of them so it will be a long time before I can make some more
on an NC Lathe. I have to make a bunch at a time to justify the set lathe up.

You can make them out of a metric bolt.
 Use a short cap screw of say 1/2"
length and drill a hole in the
center and Silver solder or braze a short tube that has a small lip
on it?

Use a metric 10 mm 1.0 thread bolt.

Paul Lamar

The Rotary Engine free News Letter. Powered by Linux. If you want off
the list PLEASE let me know and I will remove  you.  ACRE NL web
site. http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
Copyright 1998-2016 All world wide rights reserved.