Paul:

   I need two of these - could you please respond and let me know how
I can purchase these and please include the total with shipping!

   Thank you so very much!
   Berkley Thompson

   I am out of them so it will be a long time before I can make some more
   on an NC Lathe. I have to make a bunch at a time to justify the set lathe up.

   You can make them out of a metric bolt.
    Use a short cap screw of say 1/2"
   length and drill a hole in the
   center and Silver solder or braze a short tube that has a small lip
   on it?

   Use a metric 10 mm 1.0 thread bolt.

   Paul Lamar


Thanks for the quick reply I am ready put the 13-B back into the Longez so I will go the other way for now.

Berkley Thompson

Send us some picture of your Longez.

Paul Lamar

   The Rotary Engine free News Letter. Powered by Linux. If you want off
   the list PLEASE let me know and I will remove  you.  ACRE NL web
   site. http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
   Copyright 1998-2016 All world wide rights reserved.