Subject: Renesis oil pump drive gear
From: paul lamar
Date: 1/7/2017, 7:12 PM
To: A10-Me-Earthlink



Greetings all

I have a rebuilding question

I have torn down my renesis engine

I am going to use Tracies RD1-C and am going to use premix oil for the rotors.
I am tentatively considering removing the OMP drive gear and using the created
\orifice to drain the oil from the prsu to the engine. Looking at the front cover
it looks like the shaft is lubricated by oil under pressure. Using this it seems
that I have to block the passage. Any idea of how or where or should I just cap
it and find another place to plumb?

Rich Goldman


Normally we cap that whole area. I think the oil comes out around the shaft.
If you are using your ten quart oil pan there is a thick center on the top front
and that is designed for the psru drain back. You want to keep the drain back
as low as possible but just above the oil level in the pan.

Paul Lamar


The Rotary Engine free News Letter. Powered by Linux. If you want off
the list PLEASE let me know and I will remove  you.  ACRE NL web
site. http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
Copyright 1998-2017 All world wide rights reserved.