Greetings all
I have a rebuilding question
I have torn down my renesis engine
I am going to use Tracies RD1-C and am going to use premix oil for
the rotors. I am tentatively considering removing the OMP drive gear
and using the created \orifice to drain the oil from the prsu to the
engine. Looking at the front cover it looks like the shaft is
lubricated by oil under pressure. Using this it seems that I have to
block the passage. Any idea of how or where or should I just cap it
and find another place to plumb?
Rich Goldman
Normally we cap that whole area. I think the oil comes out around
the shaft. If you are using your ten quart oil pan there is a thick
center on the top front and that is designed for the psru drain
back. You want to keep the drain back as low as possible but just
above the oil level in the pan.
Paul Lamar
Thanks Paul
Rich Goldman
The Rotary Engine free News Letter. Powered by Linux. If you want off
the list PLEASE let me know and I will remove you. ACRE NL web
site.
http://www.rotaryeng.net You Tube
http://tinyurl.com/beqqxas
Copyright 1998-2017 All world wide rights reserved.