Subject: : Renesis oil pump drive gear
From: paul lamar
Date: 1/8/2017, 1:56 PM
To: A10-Me-Earthlink



  Greetings all

  I have a rebuilding question

  I have torn down my renesis engine

  I am going to use Tracies RD1-C and am going to use premix oil for
  the rotors. I am tentatively considering removing the OMP drive gear
  and using the created \orifice to drain the oil from the prsu to the
  engine. Looking at the front cover it looks like the shaft is
  lubricated by oil under pressure. Using this it seems that I have to
  block the passage. Any idea of how or where or should I just cap it
  and find another place to plumb?

  Rich Goldman


  Normally we cap that whole area. I think the oil comes out around
  the shaft. If you are using your ten quart oil pan there is a thick
  center on the top front and that is designed for the psru drain
  back. You want to keep the drain back as low as possible but just
  above the oil level in the pan.

  Paul Lamar



Thanks Paul

Rich Goldman

Hi Paul,
    Do you think the metering 'pump' drive gear is robust enough to
drive a fuel pump ? it is always good to have a mechanical / electrical
setup for fuel reliability.
    Cheers Chris.


I am not sure about the RX8. It is slightly different than the earlier models.
They are not really pumps. They are metering devices. The actual pumping
is done by the difference in air pressure  between that found around the car
and the lower air pressure inside the engine during the intake cycle.
That is why the "injectors" have one way valves.

So we are not talking very much HP here. The water pump requires 3 HP
but I have not figured out how to calculate how much HP a fuel pump would require.
Obviously a high wing tank air plane will fly on gravity flow alone.
So I guess if you are a low  wing tank pilot and you want to do inside loops
it will take more HP.

Electric pumps are in the range of 1 to 3 amps.
about 40 watts worst case. There are 746 watts in one HP so electric pumps
are in the range of .05 HP or so. That does not sound like much so maybe
the metering device drive would be enough.

It would not hurt to try as you can always rely  on  two electric pumps.
One for back up. That would extend your battery only range if you had an alternator
failure. You will need at least one electrical pump for starting with a low tank.

Paul Lamar

  The Rotary Engine free News Letter. Powered by Linux. If you want off
  the list PLEASE let me know and I will remove  you.  ACRE NL web
  site. http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
  Copyright 1998-2017 All world wide rights reserved.