Subject: Intake runner length
From: paul lamar
Date: 1/12/2017, 6:21 PM
To: A10-Me-Earthlink



Here's some interesting read on calculating the runner length for
rx7. Gets indept with lots of intake and exhaust math.

http://www.rx7club.com/general-rotary-tech-support-11/heres-how-figure-out-intake-runner-length-199788/


http://www.rx7club.com/general-rotary-tech-support-11/heres-how-figure-out-intake-runner-length-199788/



Back to planes, for the 2.85 psru gearing it looks like around 24" gives you the best HP from what I read on Pauls site. What about for Neil's upcoming psru and his 3.xx gearing, do we have a length to aim for? (I forget what the gear size is)

Right now I have 23 inches to play with. I'm just spending the day
making a plenum box, not sure if we have a volume we are striving
for.

- Matt Boiteau

Side ports. For the P-port I just copied the p-port le mans engine
as closely as possible. If you err on the long side the fuel burn
will be slightly lower at cruise.

We need to do more research on Helmholtz resonators. I suspect they
would save some space under the cowl.

Paul Lamar



So I should try to shoot closer to 18" then, not sure it's possible
with the 90degree bend and injector blocks. When you add the slide
throttle, it's almost 8 inches right there from the engine to the
end of the throttle. Wish we had an engine dyno and free time to
play around with intakes and HP.

The link I sent, the guy talks about Helmholtz resonator and how the
RX8 intake is very well done compared to older generations.

 Matt Boiteau

You are spacing your slide throttle further out than most.

Most people have kept that as short as possible for idle reasons
starting with NSU from the very beginning. Power Sport copied
NSU and put butterflies in the rotor housings.

However the time to climb p-port with the throttle on the other ends of the runners
is idling fine at 3000 RPM. 1000 prop RPM.

Runner length depends on the prop as well. What prop are you planning on?

It is not that critical. Hopefully you will have a ground adjustable prop.

Paul Lamar

The Rotary Engine free News Letter. Powered by Linux. If you want off
the list PLEASE let me know and I will remove  you.  ACRE NL web
site. http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
Copyright 1998-2017 All world wide rights reserved.