Subject: The data from the TTC runaway turbo with the manual waste gate.
From: paul lamar
Date: 1/18/2017, 9:31 AM
To: A10-Me-Earthlink



    It looks like we got ten seconds to back off  when the throttle is 100% before the
    manifold pressure runs away to infinity :-) This is at 245 feet above sea level.

    When you arrive at 100% throttle the manifold pressure is  50 inches of Mercury (Hg) and builds up rapidly
    to  52 or 53 inches of HG. Then of course it shoots up 80 inches of Hg or above. Runaway.

    It is so remarkable  that an all aluminum 200 pound  Wankel Mazda engine generating 650 HP will tolerate this.
    A piston  aircraft engine  would blow up and kill you with shrapnel. A good size bomb going off.

    The Motec is trying to open the waste gate  (if it were there) slamming it back and fourth 50% full on and 50% full off.

    The Lamda on this run was .751 which is  11 to one air fuel ratio. Quite rich but this is methanol.

    Normal for methanol is .83 which is 12.2 to one which is about the same for gasoline at full power.

    This is with a one inch hole in the bypass exhaust pipe.
    It does not runaway with the stock 1.25 inch hole under static conditions.
    Dan is going to fly it with the stock 1.25 by pass and see if it runs away away when the engine
    RPM climbs to 8,000.

    At that point we can add another parallel waste gate with a spring set to 26 inches of boost or make
    the hole in the bypass aperture larger. Say 1.3 or 1.4 inches in diameter up from 1.25 inches.

    Here is an inches of Hg to boost in psi conversion chart and the program used to generate it.
    Plus the start video.

    Paul Lamar



Paul,

According to Heywood, the AFR of methanol is 6.5:1.  Are you using pure methanol?  How did you come up with the 12:1?
Attached is a table of common fuels, their associated metrics, and a simplified method of calculating AFR.
Aaron Buster

Research Engineer
Advanced Powertrain and Emissions
Spark Ignited Engines R&D Department
Southwest Research Institute


According to our Motec expert to convert from the mixture decimal number recorded in the
Motec to a mixture ratio you multiply times 14.7.

The other thing is if it were really 6.5 :1 based on volume you would go through a 20 gallon
tank of Methanol really fast at 650 HP. We ran it for at least 26 minutes on 20 gallons.
Therefor I doubt that is the correct mixture ratio.

Paul Lamar


    The Rotary Engine free News Letter. Powered by Linux. If you want off
    the list PLEASE let me know and I will remove  you.  ACRE NL web
    site. http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
    Copyright 1998-2017 All world wide rights reserved.