Subject: Metric verses English. or French Verses English :-)
From: paul lamar
Date: 1/19/2017, 8:52 AM
To: A10-Me-Earthlink



The strength difference between a 10 mm bolt and an 8 mm bolt is
enormous. The 8 is something like 64% as strong as a 10 mm bolt. I
have never seen a 9 mm bolt. Fraction of an inch bolts are much
closer. The weight of a device will be lighter if fraction of an inch
bolts are used and just strong enough is chosen..
Paul Lamar

OK,
but this is not a fair comparison.

try 10mm to 3/8 bolt (9.525 mm)

8mm to 5/16(7.94mm), so close that you can confuse them

A 9mm bolt is not standard but they are available, just like an 11/32” bolt is
not standard, but available.

Those engineers at Mercedes Benz, Renault, TAG, Porsche,
Mazda are a bunch of dickheads, they should be using feet and inches :)

Rs,
Dave in Perth

The strength is proportional to the area which is pi r squared.
I agree but they have no choice. Metric is WW standard for cars.
Maybe in Oz you can find 9 mm or 7 mm but not in the US.
A even bigger difference is between 6 and 8 mm.
The larger you go the closer they are due to the fixed integer spacing,
What they do is make and sell you special bolts. Some Honda models have 11 mm head
bolts that cost a bunch.

The early Mazda rotaries were designed in inches but they did not use inch bolts.
This is because they were copies of CW rotary engines I suspect.

Paul Lamar


Back in the '70s when car manufacturers started building world cars they had to implement metric fasteners. For a while to remove an alternator you needed both imperial and metric wrenches. The problem there came in by the situation all new engineering was specified in metric due to worldwide adoption of the metric system. Previously engineered components were not changed. Then you wonder why mechanics have tool boxes bigger than a small car. Six and twelve point heads, clutch and torx also thrown in. Never know what you need next.

The worst was AMC deciding to use Torx security screws on the headlight bezels on the Gremlin. Had a small pin in the center so your Torx screw driver required a small hole in the center to fit over it. My '91 Sonoma pickup with 4.3 V6 had cap screws with 5.5mm 6 point heads holding the ignition module. Not a normally available socket in a small toolkit you might keep under the seat or in the trunk.
Dale Davies


The Rotary Engine free News Letter. Powered by Linux. If you want off
the list PLEASE let me know and I will remove  you.  ACRE NL web
site. http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
Copyright 1998-2017 All world wide rights reserved.