Subject: We ran the TTC today with the manual waste gate.
From: paul lamar
Date: 1/19/2017, 12:12 AM
To: A10-Me-Earthlink




The strength difference between a 10 mm bolt and an 8 mm bolt is
enormous. The 8 is something like 64% as strong as a 10 mm bolt. I
have never seen a 9 mm bolt. Fraction of an inch bolts are much
closer. The weight of a device will be lighter if fraction of an inch
bolts are used and just strong enough is chosen..

Paul Lamar

OK,
but this is not a fair comparison.

try 10mm to 3/8 bolt (9.525 mm)

8mm to 5/16(7.94mm), so close that you can confuse them

A 9mm bolt is not standard but they are available, just like an 11/32” bolt is
not standard, but available.

Those engineers at Mercedes Benz, Renault, TAG, Porsche,
Mazda are a bunch of dickheads, they should be using feet and inches :)

Rs,
Dave in Perth

The strength is proportional to the area which is pi r squared.
I agree but they have no choice. Metric is WW standard for cars.
Maybe in Oz you can find 9 mm or 7 mm but not in the US.
A even bigger difference is between 6 and 8 mm.
The larger you go the closer they are due to the fixed integer spacing,
What they do is make and sell you special bolts. Some Honda models have 11 mm head
bolts that cost a bunch.

The early Mazda rotaries were designed in inches but they did not use inch bolts.
This is because they were copies of CW rotary engines I suspect.

Paul Lamar

The Rotary Engine free News Letter. Powered by Linux. If you want off
the list PLEASE let me know and I will remove  you.  ACRE NL web
site. http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
Copyright 1998-2017 All world wide rights reserved.