Subject: Metric verses English. or French Verses English :-)
From: paul lamar
Date: 1/20/2017, 3:55 PM
To: A10-Me-Earthlink


The strength difference between a 10 mm bolt and an 8 mm bolt is
enormous. The 8 is something like 64% as strong as a 10 mm bolt. I
have never seen a 9 mm bolt. Fraction of an inch bolts are much
closer. The weight of a device will be lighter if fraction of an inch
bolts are used and just strong enough is chosen.. Paul Lamar

OK, but this is not a fair comparison.

try 10mm to 3/8 bolt (9.525 mm)

8mm to 5/16(7.94mm), so close that you can confuse them

A 9mm bolt is not standard but they are available, just like an
11/32” bolt is not standard, but available.

Those engineers at Mercedes Benz, Renault, TAG, Porsche, Mazda are a
bunch of dickheads, they should be using feet and inches :)

Rs, Dave in Perth

The strength is proportional to the area which is pi r squared. I
agree but they have no choice. Metric is WW standard for cars. Maybe
in Oz you can find 9 mm or 7 mm but not in the US. A even bigger
difference is between 6 and 8 mm. The larger you go the closer they
are due to the fixed integer spacing, What they do is make and sell
you special bolts. Some Honda models have 11 mm head bolts that cost
a bunch.

The early Mazda rotaries were designed in inches but they did not
use inch bolts. This is because they were copies of CW rotary engines
I suspect.

Paul Lamar


Back in the '70s when car manufacturers started building world cars
they had to implement metric fasteners. For a while to remove an
alternator you needed both imperial and metric wrenches. The problem
there came in by the situation all new engineering was specified in
metric due to worldwide adoption of the metric system. Previously
engineered components were not changed. Then you wonder why
mechanics have tool boxes bigger than a small car. Six and twelve
point heads, clutch and torx also thrown in. Never know what you need
next.

The worst was AMC deciding to use Torx security screws on the
headlight bezels on the Gremlin. Had a small pin in the center so
your Torx screw driver required a small hole in the center to fit
over it. My '91 Sonoma pickup with 4.3 V6 had cap screws with 5.5mm
6 point heads holding the ignition module. Not a normally available
socket in a small toolkit you might keep under the seat or in the
trunk.

Dale Davies


There is no metric system. It is called the S.I. for System
International

Long time ago, the British agreed to switch to the S.I. In return
for the change of the meridians starting in Greenwich (previously the
0 degree meridian was going through the Paris national observatory)

The meridian was changed but the britts never made good on the
promise of going S.I.

Ph. Chenevier Toulouse France

Last time I was in London the zero meridian was still in Greenwich.

GMT is still used in navigation and all of aviation as far as I
know.

If you have a clock that shows GMT you can find your longitude
anywhere in the world at noon each day. If they changed the location
of the zero meridian absolutely  nothing in the world would be in the
same place.

Paul Lamar

Remarkable!  The area of a 10mm bolt is 63% greater than an 8mm
bolt.

Joel Mayhall Over the Hill Ceramic Materials Engr


The Rotary Engine free News Letter. Powered by Linux. If you want off
the list PLEASE let me know and I will remove  you.  ACRE NL web
site. http://www.rotaryeng.net <http://www.rotaryeng.net/You Tube
http://tinyurl.com/beqqxas Copyright 1998-2017 All world wide rights
reserved.