Subject: TTC 650 HP manifold pressure relief valve
From: paul lamar
Date: 1/25/2017, 11:52 AM
To: A10-Me-Earthlink

When I bought this it came with a spring that was set to about 25 psi
boost. We did not want to test fly with that amount of boost so
I have looking for a weaker spring that would work.

After considerable analysis I discovered how to find a spring that
will work. This is very important so  if you ever want to build a turbo
engine so file this message.

The geometry of the valve limits the dimensions of the spring.
In my case 1.2 to 1.5 inches in diameter. The uncompressed lenth
is 4.0 inches.

blow off spring 4 inches long

OD 1.4 inches  ID 1.164

.133 wire diameter 8 or 9 turns

the valve is 2.63 square inches area

at 20 psi that is 52 pounds.

Spring is compressed 1.75 inches so the load is 66.5 pounds
thus

If we use the 4 inch 0.125 dia below the rate is 28.16 Lb/in there fore  1.75 inches the load is 49.00 pounds

20 psi is 2.63 sq in is  52 pounds

25 psi is 2.63 sq in is 65.75 pounds.

30 psi is X 2.63 sq in is 78.9 pounds

Current spring rate is 38 pounds per inch

McMaster Carr useful springs.
Overall-. OD----ID-----Wire ..........Wire-- Wire -Compress--- Max--. Rate,
Length..............Dia. ...Thick.'''''''..Wd......Lenth...Load---Lbs/In

4".   ..  1.219"    0.969"    0.125"    __    _______-_1.49" 72.00    28.16    6    9657K467    13.33

Turns out the only useful variable is spring rate.
The main factors are wire size and number of turns. Fewer turns higher rate'
Larger wire higher rate.

The video shows how to measure the spring rate. You put the spring on a scale
and push down on it until the scale platform moves one Inch down.

Here are a bunch of related pictures and a video.

Paul Lamar