Subject: what is the best way to do this. Machining problem
From: paul lamar
Date: 2/6/2017, 10:24 AM
To: A10-Me-Earthlink

I have the steady rest frame bolted to my rotary table.

I have two roughing end mills. The big one shown
and some 3/8 on the way. I broke a 5/16th already.

Roughly speaking, is it better to run the cutter at high RPM
when cutting these sever discontinuities or low RPM?

Big cutter or small cutter?

I would like to keep the chatter down.

Paul Lamar

The Rotary Engine free News Letter. Powered by Linux. If you want off
the list PLEASE let me know and I will remove  you.  ACRE NL web
site. http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
Copyright 1998-2017 All world wide rights reserved.