Subject: what is the best way to do this. Machining problem
From: paul lamar
Date: 2/6/2017, 12:12 PM
To: A10-Me-Earthlink


I have the steady rest frame bolted to my rotary table.

I have two roughing end mills. The big one shown and some 3/8 on the
way. I broke a 5/16th already.

Roughly speaking, is it better to run the cutter at high RPM when
cutting these sever discontinuities or low RPM?

Big cutter or small cutter?

I would like to keep the chatter down.

Paul Lamar


find a 4 jaw lath big enough to chuck that bad boy in and turn it
down from the inside ?

Thomas Kimsey

I know where one is but getting access to it is problematic.

Paul Lamar

The Rotary Engine free News Letter. Powered by Linux. If you want
off the list PLEASE let me know and I will remove  you.  ACRE NL web
site. http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
Copyright 1998-2017 All world wide rights reserved.