Subject: what is the best way to do this. Machining problem
From: paul lamar
Date: 2/6/2017, 12:33 PM
To: A10-Me-Earthlink



I have the steady rest frame bolted to my rotary table.

I have two roughing end mills. The big one shown and some 3/8 on the way. I broke a 5/16th already.

Roughly speaking, is it better to run the cutter at high RPM when cutting these sever discontinuities or low RPM?

Big cutter or small cutter?

I would like to keep the chatter down.

Paul Lamar

Paul,
If the total depth of cut is short, run a short tool. We always run the shortest too possible. If your had control of the feed, I could give you feeds and speeds to run, but being done manually, run medium rpm on the spindle and vary the feed rate to get a good chip. Leave yourself about .010 for a finish pass to get a good surface finish. Also always use the largest diameter tool that will fit (size does matter!)
Cheers,
Larry Childs


That one inch I have in there now is pretty stiff.

Thanks Larry.


The Rotary Engine free News Letter. Powered by Linux. If you want off
the list PLEASE let me know and I will remove  you.  ACRE NL web
site. http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
Copyright 1998-2017 All world wide rights reserved.