Subject: what is the best way to do this. Machining problem
From: paul lamar
Date: 2/6/2017, 12:34 PM
To: A10-Me-Earthlink



   I have the steady rest frame bolted to my rotary table.

   I have two roughing end mills. The big one shown
   and some 3/8 on the way. I broke a 5/16th already.

   Roughly speaking, is it better to run the cutter at high RPM
   when cutting these sever discontinuities or low RPM?

   Big cutter or small cutter?

   I would like to keep the chatter down.

   Paul Lamar


Slower speed and feed, cutting fluid, and minimize intermittent cutting

Steve Carlisle



   The Rotary Engine free News Letter. Powered by Linux. If you want off
   the list PLEASE let me know and I will remove  you.  ACRE NL web
   site. http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
   Copyright 1998-2017 All world wide rights reserved.