Subject: what is the best way to do this. Machining problem
From: paul lamar
Date: 2/6/2017, 12:43 PM
To: A10-Me-Earthlink


I have the steady rest frame bolted to my rotary table.

I have two roughing end mills. The big one shown
and some 3/8 on the way. I broke a 5/16th already.

Roughly speaking, is it better to run the cutter at high RPM
when cutting these sever discontinuities or low RPM?

Big cutter or small cutter?

I would like to keep the chatter down.

Paul Lamar

First thing to consider is "what type of material" are you working on, type of cutter used, speed, and feed "or bite" of cutter. And lastly do you need lubricant?. Attached is a good general guide. It has table speeds, and good info.

Keep making chips.

regards,
Norm Parmely

Thanks Norm. I did not know the Army taught machining.
Very interesting document.

Paul Lamar

The Rotary Engine free News Letter. Powered by Linux. If you want off
the list PLEASE let me know and I will remove  you.  ACRE NL web
site. http://www.rotaryeng.net <http://www.rotaryeng.net/>You Tube http://tinyurl.com/beqqxas
Copyright 1998-2017 All world wide rights reserved.