Subject: what is the best way to do this. Machining problem
From: paul lamar
Date: 2/6/2017, 10:47 PM
To: A10-Me-Earthlink



    I have the steady rest frame bolted to my rotary table.

    I have two roughing end mills. The big one shown and some 3/8 on the
    way. I broke a 5/16th already.

    Roughly speaking, is it better to run the cutter at high RPM when
    cutting these sever discontinuities or low RPM?

    Big cutter or small cutter?

    I would like to keep the chatter down.

    Paul Lamar


    find a 4 jaw lath big enough to chuck that bad boy in and turn it
    down from the inside ?

    Thomas Kimsey

   I know where one is but getting access to it is problematic.


   Paul Lamar


Or attach it to a lathe faceplate, and use a boring bar !

Steve Carlisle


I try to use what I have with out spending a lot of money.

Paul Lamar

    The Rotary Engine free News Letter. Powered by Linux. If you want
    off the list PLEASE let me know and I will remove  you.  ACRE NL web
    site. http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
    Copyright 1998-2017 All world wide rights reserved.