Subject: New encoders on the Kasuga
From: paul lamar
Date: 2/20/2017, 7:06 PM
To: A10-Me-Earthlink



I am installing new CUI encoders on the Kasuga as per David Mikesell
recommendation. I am keeping the tach's as the servo amps require
tach feed back. I think it has something  to do with the PID. I could
be wrong as I am a real novice at  building NC machines.

I found out the servo motors I have are selling on EBay for $1300
each. The servo amps are about $300 each if you can find them. New
amps are even more.

I got to get this kasuga working to make gear boxes and end
housings.

My zero run out adjustable chuck is a pleasure to use.

I highly recommend it if you have a 3 jaw that has some run out.

I have also figured out a way to adjust the perpendicularity.

Right now it is slightly off out about  foot or 2 away from the
chuck. That means the chuck is not quite perpendicular to the lathe
axis. Four more 10-32 set screws are the answer mounted behind the
chuck. We are talking microns here :-)


Paul Lamar


Paul, I think you will find that your headstock is not parallel to
your ways. You cannot improve that by setting your chuck askew on
your spindle to chuck mounting face. .

Steve Carlisle

That may or may not be the case. Since I machined the back flange chuck adapter I probably
screwed up.

We shall find out.

Paul Lamar

The Rotary Engine free News Letter. Powered by Linux. If you want
off the list PLEASE let me know and I will remove  you.  ACRE NL web
site. http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
Copyright 1998-2017 All world wide rights reserved.