Subject: New encoders on the Kasuga
From: paul lamar
Date: 2/21/2017, 3:43 PM
To: A10-Me-Earthlink



 I am installing new CUI encoders on the Kasuga as per David Mikesell
 recommendation. I am keeping the tach's as the servo amps require
 tach feed back. I think it has something  to do with the PID. I could
 be wrong as I am a real novice at  building NC machines.

 I found out the servo motors I have are selling on EBay for $1300
 each. The servo amps are about $300 each if you can find them. New
 amps are even more.

 I got to get this kasuga working to make gear boxes and end
 housings.

 My zero run out adjustable chuck is a pleasure to use.

 I highly recommend it if you have a 3 jaw that has some run out.

 I have also figured out a way to adjust the perpendicularity.

 Right now it is slightly off out about  foot or 2 away from the
 chuck. That means the chuck is not quite perpendicular to the lathe
 axis. Four more 10-32 set screws are the answer mounted behind the
 chuck. We are talking microns here :-)


Paul Lamar


 Paul, I think you will find that your headstock is not parallel to
 your ways. You cannot improve that by setting your chuck askew on
 your spindle to chuck mounting face. .

 Steve Carlisle

That may or may not be the case. Since I machined the back flange chuck
adapter I probably
screwed up.

We shall find out.

Paul Lamar

I discovered a problem with the CUI Inc encoders.
The tiny connector requires #28 or #30 wire. The wire in my mill
for decoders is at least #20 or larger. The smaller the number
the larger the wire. That #30 would be fine if you were controlling
your NC Mill with a cell phone :-) The female connector pins
are so small you almost need a microscope to see them let alone
solder wires to them.


 CUI Inc offers a made up cable but it is only 3 feet long and cost
a whopping $50. The same price as the encoders. I need three. They are
giving you the handle for the shaver and ripping you off for the blades :-)
Same as ink jet printers almost. However I can see why they cost so
much because they are so difficult to make.

So here is what I am going to do. I am going to have 3 of these
PC board made.Each board has 12 adapters.I will then have 36 small printed
circuit boards I can solder the connector pins in and the #20 wire NC mill
wiring. So if somebody wants some of these let me know.

Paul Lamar

 The Rotary Engine free News Letter. Powered by Linux. If you want
 off the list PLEASE let me know and I will remove  you.  ACRE NL web
 site. http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
 Copyright 1998-2017 All world wide rights reserved.