Hi Paul,
I’m working on the oil system for the Renesis in my plane. I plan on a
remote oil filter. I see the ID of the stock passages, tubing and
fittings is about 3/8” in most locations.
I have not found clear recommendations for the ideal sizing of these
lines in the prior posts and publications related to aircraft.
While we know that size matters, if I need to cool about 180-200hp, is
there any advantage to the extra weight and bulk for larger fittings and
hoses by going to AN-10 or larger, instead of staying with the stock
sizes (3/8 ID) that would correspond to AN-8 ?
Also, do you see any disadvantage to using 5052 aluminum lines for any
runs that are fixed (e.g. oil cooler base to remote location, redrive, etc.?
Thanks,
Scott Gettings
Some people use AN -10 but IMHO that is over Kill. I would use AN-8.
In these RV4 pictures the only thing not AN-8 is the gear box supply
and drain back. The TTC plumbing is a night mare :-) I did not do that :-)
If I was allowed to revise it I would do it in a heart beat :-)
Some of the TTC has -10 or larger and that is needed for 650HP.
The OD of the -8 braided hose is about .6 inch and the ID is about .34.
Not quite 3/8 at .375.
If you use solid metal lines (pipe) they are 1/2 inch OD.
Paul Lamar
The Rotary Engine free News Letter. Powered by Linux. If you want off
the list PLEASE let me know and I will remove you. ACRE NL web
site.
http://www.rotaryeng.net You Tube
http://tinyurl.com/beqqxas
Copyright 1998-2017 All world wide rights reserved.