Subject: sachs oil cooled question
From: paul lamar
Date: 3/9/2017, 9:46 AM
To: A10-Me-Earthlink



Hey Paul, have a question for you. In oil cooling the sachs we should have to make new end plates. Plus we'll need to add better side scraper seals to the rotor to keep the oil from getting into the combustion chamber. Do you suggest using modified cast-iron seals from the 13b be cut to fit or the new ceramic seals that you talked about that have 20,000 expected life

David Mikesell
San Jose, CA

Those ceramic seals are for the apex seals. You may or not be able
to find those for the Sach. If you could learn how to make them it would be a good
biz as they sell for $200 each.

There is not really enough room on the sachs rotor to put side oil
seals. What happens is the oil leaks down past the side compression seals
and pools in the bottom of the engine when it is not running. When you start it
up it smokes like the devil for a few minutes.  I hope the devil gets cancer and dies :-)

Your might have room for one large section Teflon encapsulated silicon O ring.

Could be worth a try if it don't wear out right away.

Paul Lamar

The Rotary Engine free News Letter. Powered by Linux. If you want off
the list PLEASE let me know and I will remove  you.  ACRE NL web
site. http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
Copyright 1998-2017 All world wide rights reserved.