Subject: design of the end housings
From: paul lamar
Date: 4/10/2017, 8:44 AM
To: A10-Me-Earthlink


I am also working on the design of
the end housings. The rear is
 quite simple.

 The front end housing
must accommodate a water pump. Does anybody
 have any preferences for
water pumps. 2nd gen or RX8? Or some else
 perhaps?

 The oil pump with be a
dry sump pump with choices of several brands.


 Pual Lamar


In regard to your waterpump choice
question I would like to comment. If
designing a different front cover, the
water pump chosen firstly needs
to meet the flow requirements of the
engine. The pulley needs to match
with regard to belt type and width as
well as diameter. Then replacement
cost and availabiliry need
consideration. Accessability at any location
in firstly N. America and potentially
the world should be taken into
consideration. Possibly the pump from a
Cummins diesel as installed in
Dodge or Ram trucks would work.
Dale Davies



Paul
I like the 2nd generation RX8 pump.
From left to right: 2nd gen RX8, 1st gen RX8 and Remedy RX8  (See
attached).
Barry Bordes

Steve, if you are making a housing it can be tailored to a pump of your choice.
Dale Davies

The Rotary Engine free News Letter. Powered by Linux. If you want off
the list PLEASE let me know and I will remove  you.  ACRE NL web
site. http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
Copyright 1998-2017 All world wide rights reserved.