Subject: design of the end housings
From: paul lamar
Date: 4/10/2017, 9:33 AM
To: A10-Me-Earthlink


    I am also working on the design of
     the end housings. The rear is
      quite simple.

      The front end housing
     must accommodate a water pump. Does anybody
      have any preferences for
     water pumps. 2nd gen or RX8? Or some else
      perhaps?

      The oil pump with be a
     dry sump pump with choices of several brands.


      Pual Lamar


     In regard to your waterpump choice
     question I would like to comment. If
     designing a different front cover, the
     water pump chosen firstly needs
     to meet the flow requirements of the
     engine. The pulley needs to match
     with regard to belt type and width as
     well as diameter. Then replacement
     cost and availabiliry need
     consideration. Accessability at any location
     in firstly N. America and potentially
     the world should be taken into
     consideration. Possibly the pump from a
     Cummins diesel as installed in
     Dodge or Ram trucks would work.
     Dale Davies



    Paul
     I like the 2nd generation RX8 pump.
     From left to right: 2nd gen RX8, 1st gen RX8 and Remedy RX8 (See
     attached).
    Barry Bordes

    Steve, if you are making a housing it can be tailored to a pump of your choice.
    Dale Davies

Hi Dale, as I see it, there are 2 paths to follow with housing development, the first being
Racing Beat housings (stock format), Richard Sohn type, also stock format,
or Paul's LSA design, front and rear housing can be the same, coolant holes can have
crossover hose or plugged.

Steve Carlisle

    The Rotary Engine free News Letter. Powered by Linux. If you want off
    the list PLEASE let me know and I will remove  you.  ACRE NL web
    site. http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
    Copyright 1998-2017 All world wide rights reserved.