Subject: design of the end housings
From: paul lamar
Date: 4/10/2017, 10:52 AM
To: A10-Me-Earthlink




I am also working on the design of
 the end housings. The rear is
  quite simple.

  The front end housing
 must accommodate a water pump. Does anybody
  have any preferences for
 water pumps. 2nd gen or RX8? Or some else
  perhaps?

  The oil pump with be a
 dry sump pump with choices of several brands.


  Pual Lamar


 In regard to your waterpump choice
 question I would like to comment. If
 designing a different front cover, the
 water pump chosen firstly needs
 to meet the flow requirements of the
 engine. The pulley needs to match
 with regard to belt type and width as
 well as diameter.

Then replacement
 cost and availabiliry need
 consideration. Accessability at any location
 in firstly N. America and potentially
 the world should be taken into
 consideration. Possibly the pump from a
 Cummins diesel as installed in
 Dodge or Ram trucks would work.
 Dale Davies



Paul
 I like the 2nd generation RX8 pump.
 From left to right: 2nd gen RX8, 1st gen RX8 and Remedy RX8 (See
 attached).
Barry Bordes

Steve, if you are making a housing it can be tailored to a pump of your choice.
Dale Davies

    Hi Dale, as I see it, there are 2 paths to follow with housing development, the first being
    Racing Beat housings (stock format), Richard Sohn type, also stock format,
    or Paul's LSA design, front and rear housing can be the same, coolant holes can have
    crossover hose or plugged.

    Steve Carlisle


RB housings are about $1500 each. What are the costs and availability nation wide of rotary water pumps? You do not want to fly somewhere and be stuck waiting for days for parts that should be shelf or next day items. That is my idea why a part from a currently prodced vehicle with mass production is important. One part may be less expensive but not well stocked which makes a part that is a few dollars more costly but widely available a better choice. If the market is there, casting an adapter to bolt on Mazda engines and use a more commonly available pump may be feasible.


My personal thought on cooling is that the water pump outlet should go into the RX8 center housing by the exhaust ports with small lines to the end housing ports. Coolant flow blocked between the area of the spark plugs so it is forced to flow through the hot sides of the rotor housings to the front and rear end housings. There it would be allowed ot flow up and then back through the rotr housings to be collected just above the center intake port. For AC use pport intake would free up that area to bolt on a water manifold out to the radiator. This would even up cooling to the two rotors, and help cool the exhaust port area especially the center pair. This would help prevent cracking in turbocharged applications.

Dale Davies

The hottest part of the rotor housings is near the lower spark plug holes.
If it were not for the squish wind it would be the upper spark plug hole :-)

In a multi rotor you want parallel cooling. Not serial cooling as in the stock
Mazda. This has been known since the earliest days of the aircraft engine.

Read Herschel Smith's  "A History of Aircraft Piston Engines" Worth
ten times what it cost.


Paul Lamar


The Rotary Engine free News Letter. Powered by Linux. If you want off
the list PLEASE let me know and I will remove  you.  ACRE NL web
site. http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
Copyright 1998-2017 All world wide rights reserved.