Subject: squish flow reduction Break Through Illustration
From: paul lamar
Date: 4/11/2017, 8:21 PM
To: A10-Me-Earthlink


 Hi Paul;
 If you're looking at doing rotor & efficiency mods - Take another
 look at the SAE841017 - recent 84 tech pg 6, Fig 14,13,20, note
 very low BSFC @ 7500rpm in fig.14 for the large pport. And the
 81RE-KY bible p.48-49-53 LDR/MDR/L-flat charts for BSFC/MEP
 improvements.

Cheers  Cary Beazley

 The 81RE-Ken Yamamoto  bible p.48-49-53 LDR/MDR/L-flat charts for BSFC/MEP
 improvements are within the margin of measurement  error IMHO. Notice
 the RX 8 used neither :-) The bathtub  is symmetrical and wider.

 Here is the combust data out of the 84 paper.

 It implies there is a difference in pressure at the spark plug
 holes !!!!!!!

 If the pressure is not equal the force vector is deflected.

 More data is needed with more pressure sensors. One every 1/4 inch or
 even 1 every 1/2 inch.

 More work needs to be done on the bath tubs.
And the wind problem.

 Paul Lamar

Yep, may very well be measurement or calibration error - definitely a
difference between the the 81 bible and 84 tech papers, & CW papers.
Fully agree on the need for more research and maybe see the latest
direct injection and ignition research.
I would argue the rx8 side port configuration might have been chosen
more to reduce emissions with more focus on low-mid power drive-ability.

I'm still looking for an old chart showing the BSFC/BMEP due to side
port turbulence swirl.

Cary  Beazley

Well I got my Rhino up and running and  drew some rotors.
I was amazed again at a small difference in the location of the center of the pressure
vector relative to the center of the rotor surface made so much difference in
the torque generated.

One reason for this is the extremely short stroke of the e-shaft.

If the center of pressure is off by as little as an inch a large
difference in the amount of torque generated when the e-shaft
is 90 degrees beyond  TDC and the rotor has rotated 30 degrees.

There is also a torque  on the rotor about it's center reacted by the stationary gear.

The e-shaft moment arm drastically changes.

The very best configuration is move the center of pressure as
far upstream or aft as you far as you can get it.

Given the geometry it is amazing
the Wankel is so close to the piston engine.

Paul Lamar


The Rotary Engine free News Letter. Powered by Linux. If you want off
the list PLEASE let me know and I will remove  you.  ACRE NL web
site. http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
Copyright 1998-2017 All world wide rights reserved.