Subject: design of the end housings
From: paul lamar
Date: 4/12/2017, 10:41 AM
To: A10-Me-Earthlink


     I am also working on the design of the end housings. The rear is
       quite simple.

       The front end housing must accommodate a water pump. Does anybody
       have any preferences for water pumps. 2nd gen or RX8? Or some else
       perhaps?

       The oil pump with be a dry sump pump with choices of several brands.


       Pual Lamar


   In regard to your waterpump choice question I would like to comment. If designing a different front cover, the water pump chosen firstly needs to meet the flow requirements of the engine. The pulley needs to match with regard to belt type and width as well as diameter. Then replacement cost and availabiliry need consideration. Accessability at any location in firstly N. America and potentially the world should be taken into consideration. Possibly the pump from a Cummins diesel as installed in Dodge or Ram trucks would work.
   Dale Davies


I think it matters to which type of end housing design you have chosen !

Steve Carlisle

<Rotaryview.jpg>


Can someone please clue me in on the engine on the right in this photo from back on April 9?  Is there a write-up on this engine somewhere?  I tried to blow it up and read the placard on the bottom, but the photo resolution is too low.

Dave Klingler

It is an old Power Sport light weight engine. Did you miss that thread?

Here is some more stuff  on the Old Power Sport.

Paul Lamar

The Rotary Engine free News Letter. Powered by Linux. If you want off
the list PLEASE let me know and I will remove  you.  ACRE NL web
site. http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
Copyright 1998-2017 All world wide rights reserved.