Paul, what year rotary engine would be the best choice to get 300-350 hp
with turbo charging (for an airplane)? I am looking for a complete
running unit. -jw
James Whitehurst
Anything after 1989. Best to get a running car. Then you can do a
compression check.
Before 2004 the nylon lines that feed oil to the apex seals get brittle
and some times
crack. If the engine is running however you can do a compression check and
if that is OK the engine is fine.
2004, 2005 RX8 suffered from the same problem as Mazda cut back too far
on the apex seal oil for smog reasons. Mazda gave people a new engine.
My 2004 is still running great as i always put in an extra one ounce per
gallon
of 2 cycle each time i filled the tank from day one.
About 2006 Mazda fixed it with three oil injectors per rotor and a bit more
apex seal oil. Some early RX8 computers were re flashed to increase the oil.
Now if you don't mind learning how to take them apart you can get a real
old junker and practice taking it apart and putting it back together.
It is real easy once you do it once. Lots of Video's on how to do it on
youtube.
Then you can put in 20,000 hour life silicon nitride apex seals. About
$1200 to
$1500 for a set. It will run long after you die if you are now 20 years
old :-)
Assuming you are consistent about mixing 2 ounces of apex seal oil per
gallon
of fuel.
Here are some picture of an aircraft with a side port turbo I did.
Paul Lamar
The Rotary Engine free News Letter. Powered by Linux. If you want off
the list PLEASE let me know and I will remove you. ACRE NL web
site.
http://www.rotaryeng.net You Tube
http://tinyurl.com/beqqxas
Copyright 1998-2017 All world wide rights reserved.