Subject: Different rotor housing on used engine
From: paul lamar
Date: 6/6/2017, 8:04 PM
To: A10-Me-Earthlink


trying to find out more on rotor housing types, and came across this link, https://www.rx7club.com/2nd-generation-specific-1986-1992-17/rotor-housing-iron-differences-988148/page2/

Scroll down to the Mazda Aviation Division, quit a lot of info on rotor housings.

Steve Carlisle

All turbo engines had the front housing drilled and taped for the turbo oil
supply.   That is into the oil gallery that ran along the top of the engine.

Only the 3rd gen, which were all turbo engines, had the hollow
dowel pin area on the rear housing beefed up. The load on this
depends on where the motor mounts are located and that varied
from 2nd gen to 3rd gen.

That is all I know about it. I suspect the rest of it was the same as all
other 13B RX7 housings. The RX8 never had a turbo.

However when it comes to side ports there were variations. But that does
not matter if your using p-ports which you should be doing. A huge increase
in power over all side port configurations.

Paul Lamar

The Rotary Engine free News Letter. Powered by Linux. If you want off
the list PLEASE let me know and I will remove  you.  ACRE NL web
site. http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
Copyright 1998-2017 All world wide rights reserved.