Paul, would it be better to weld aluminum o-ring collar for the PP
intake tube to the outer housing instead of screwing and epoxy as seen
in some of the drawings? ( i have the capability in house) long
term/reliable bonding to aluminum with epoxy is a very tricky and
questionable proposition. -jw
James Whitehurst
Well the stainless steel p-port tube is welded to the steel rotor
housing.
No way of welding it to the outer housing which is aluminum.
For years people bonded in an aluminum p-port tube.
That was very problematic and un reliable. It would work for
a while and then it would leak. It would leak water into the combustion
chamber or just out of the block. We worked on this for months trying
to come up with a reliable way of doing it.
Welding in the steel tube was a major breakthrough. We now have about
200,000 hits on you tube. A very large number for a rotary video.
Here are some pictures from the old days when attempting to bonding it.
The new way with the bolted on block can be repaired. Just a matter
of redoing the silicon rubber or replacing the O ring.
You might try welding the outer block with the O-ring slot to the outer
rotor housing. But I would do that in stages to keep the rotor
housing from
getting too hot and warping.
New Rotor housing are very expensive.
Paul Lamar
How about using Al tube? Trim inside to match the rotor housing contour.
Pull back a bit from the stainless and weld to the Al backing of the
rotor housing. Then weld the tube to the outside of the rotor housing.
Considering this is in a lower temperature area of the housing,
expansion and contraction should not be a big issue.
Dale Davies
Yes that might work. Somebody with a junk rotor housing should try it
Paul Lamar.
The Rotary Engine free News Letter. Powered by Linux. If you want off
the list PLEASE let me know and I will remove you. ACRE NL web
site.
http://www.rotaryeng.net You Tube
http://tinyurl.com/beqqxas
Copyright 1998-2017 All world wide rights reserved.