Subject: Warp drive hub non NC mill version
From: paul lamar
Date: 6/12/2017, 12:01 AM
To: A10-Me-Earthlink

Most people that have NC Mill's need to pay for them.
That increases the cost of the parts.

Here is a version of the warp drive hub/prop-flange/combination.
It weighs more but it can be built with just any old  lathe.

Twelve 3/8" set point screws anchor it to the hollow prop shaft.

Anybody have a big lathe that can turn 9 inch diameter?
I can send you the round blanks.
It would be nice if you had Rhino or Solid Works but not essential.

I need a set front and back for the gear box prototype.

BTW the best blade I have seen so far is the Sensenich.
The secret to more HP is a wider blade.


Paul Lamar

The Rotary Engine free News Letter. Powered by Linux. If you want off
the list PLEASE let me know and I will remove  you.  ACRE NL web
site. http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
Copyright 1998-2017 All world wide rights reserved.