Subject: Warp drive hub non NC mill version
From: paul lamar
Date: 6/12/2017, 1:04 PM
To: A10-Me-Earthlink


Most people that have NC Mill's need to pay for them. That
increases the cost of the parts.

Here is a version of the warp drive hub/prop-flange/combination. It
weighs more but it can be built with just any old  lathe.

Twelve 3/8" set point screws anchor it to the hollow prop shaft.

Anybody have a big lathe that can turn 9 inch diameter? I can send
you the round blanks. It would be nice if you had Rhino or Solid
Works but not essential.

I need a set front and back for the gear box prototype.

BTW the best blade I have seen so far is the Sensenich. The secret
to more HP is a wider blade.


Paul Lamar


I have a 16" lathe, but how would you guarantee 120 degree placement
of the blade mounts? Even the slightest offset would cause
significant vibration.

That being said, if I turned it down a local shop here has an NC mill
that could drill the blanks. Their costs are reasonable, $70 an hour.


Kevin Alderman

That is a good hourly rate for an NC shop.
If you give me the name I will request some quotes.

I have a rotary table.

Here is a company that keeps a low profile but they have great prices
on machine tools.
http://www.shars.com/
down load the pdf catalog.

In case you need a rotary table.

Paul Lamar



The Rotary Engine free News Letter. Powered by Linux. If you want off
the list PLEASE let me know and I will remove  you.  ACRE NL web
site. http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
Copyright 1998-2017 All world wide rights reserved.