Subject: Warp drive hub non NC mill version
From: paul lamar
Date: 6/12/2017, 11:22 PM
To: A10-Me-Earthlink


    Most people that have NC Mill's need to pay for them. That
    increases the cost of the parts.

    Here is a version of the warp drive hub/prop-flange/combination. It
    weighs more but it can be built with just any old  lathe.

    Twelve 3/8" set point screws anchor it to the hollow prop shaft.

    Anybody have a big lathe that can turn 9 inch diameter? I can send
    you the round blanks. It would be nice if you had Rhino or Solid
    Works but not essential.

    I need a set front and back for the gear box prototype.

    BTW the best blade I have seen so far is the Sensenich. The secret
    to more HP is a wider blade.


    Paul Lamar


    I have a 16" lathe, but how would you guarantee 120 degree placement
    of the blade mounts? Even the slightest offset would cause
    significant vibration.

    That being said, if I turned it down a local shop here has an NC mill
    that could drill the blanks. Their costs are reasonable, $70 an hour.


    Kevin Alderman

   That is a good hourly rate for an NC shop.
   If you give me the name I will request some quotes.

   I have a rotary table.

   Here is a company that keeps a low profile but they have great prices
   on machine tools.
   http://www.shars.com/
    down load the pdf catalog.

   In case you need a rotary table.


   Paul Lamar

Kevin, you can clamp a degree wheel to the rear of the spindle, and index from there!

Steve carlisle


   The Rotary Engine free News Letter. Powered by Linux. If you want off
   the list PLEASE let me know and I will remove  you.  ACRE NL web
   site. http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
   Copyright 1998-2017 All world wide rights reserved.