What EFI or carb are you planning on using?
Paul Lamar
I have been planning on using Tracy's at this point (purchased years
ago), but would love to have another, more practical EFI solution
that does not involve detailed programming.
Scott Gettings
How close are you to running Scott ?
I would write the program and build the injection hardware.
Are you willing to use an M&W CD ignition?
That greatly simplifies the hardware and software.
Paul
Most likely yes. I purchased Tracy's EFI but have no problem replacing
it with another, more practical alternative. Will M&W allow using the
stock injectors and coils?
My fuel system is otherwise done. My plan is to finalize all the
components and wring out the entire pusher configuration in an airboat.
This will avoid having too many new systems to deal with in flight testing.
I'm still searching for the best radiator cores to weld into a folded,
cross counterflow unit (4 total of about 15x20x1"). I think the best
oil cooler option (considering all your input--thanks!!) is two, appx
5x20x2" units in the lower, rear cowl, fed by under-wing ducts blending
into K&L diffusers and exit ducts ending in front of the pusher prop to
assure low pressure. The other options have structural issues that
prevent their implementation.
So, I think I'm 90% done, but also unfortunately have 90% to go :-)
Scott Gettings
M&W has absolutely nothing to do with the injection system. It does
ignition only.
However Tracy's and most other system uses stock inductive coils. This
requires
the injection system computer to calculate the correct time to turn the
coils on
and off when the spark occurs.
Take that software out of the EFI system and it becomes much simpler to
control just the injection. A slower, much easier to program, computer
will now do the
injection work. If one is used per rotor that is even less work for the
software.
The software can now act as a black box and record all the engine parameter
as often as ten times a second. Of course if one computer fails the engine
will still run on the other. The reliability is going to depend on how
good the
wire connections are made.
Paul Lamar
The Rotary Engine free News Letter. Powered by Linux. If you want off
the list PLEASE let me know and I will remove you. ACRE NL web
site.
http://www.rotaryeng.net You Tube
http://tinyurl.com/beqqxas
Copyright 1998-2017 All world wide rights reserved.