Subject: Warp drive hub non NC mill version
From: paul lamar
Date: 6/13/2017, 11:28 AM
To: A10-Me-Earthlink



    Most people that have NC Mill's need to pay for them. That increases
    the cost of the parts.

    Here is a version of the warp drive hub/prop-flange/combination. It
    weighs more but it can be built with just any old  lathe.

    Twelve 3/8" set point screws anchor it to the hollow prop shaft.

    Anybody have a big lathe that can turn 9 inch diameter? I can send
    you the round blanks. It would be nice if you had Rhino or Solid
    Works but not essential.

    I need a set front and back for the gear box prototype.

    BTW the best blade I have seen so far is the Sensenich. The secret to
    more HP is a wider blade.


    Paul Lamar


    I have a 16" lathe, but how would you guarantee 120 degree placement
    of the blade mounts? Even the slightest offset would cause
    significant vibration.

    That being said, if I turned it down a local shop here has an NC
    mill that could drill the blanks. Their costs are reasonable, $70 an
    hour.


    Kevin Alderman

    That is a good hourly rate for an NC shop. If you give me the name I
    will request some quotes.

    I have a rotary table.

    Here is a company that keeps a low profile but they have great
    prices on machine tools. http://www.shars.com/ down load the pdf
    catalog.

    In case you need a rotary table.


    Paul Lamar

    Kevin, you can clamp a degree wheel to the rear of the spindle, and
    index from there!

    Steve carlisle


   Steve, I know about the degree wheel, but the bolt holes aren't my concern. It's the prob blade holes. Just 1 degree off or not perfectly bored and I get to spend a day trying to balance it.

   Making it round and bolting it together is the easy part. I figured I could turn out the blanks and the local shop do the bores.

   Kevin Alderman

   Check with Sensenich on the shank dimensions and see if they are the same as
   the warp drive.

   You will have to static balance it in any case. You will need to make a short shaft to do
   this and two parallel bars to do it on. Static balance is sufficient as blade
   deflection out of plane will happen no matter what. The quality control
   on the blade is most important for dynamic balance.

   Paul Lamar


Kevin, is not the 120 degrees the same on the face as the periphery ?

Steve Carlisle



    The Rotary Engine free News Letter. Powered by Linux. If you want
    off the list PLEASE let me know and I will remove  you.  ACRE NL web
    site. http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
    Copyright 1998-2017 All world wide rights reserved.