Subject: Warp drive hub non NC mill version
From: paul lamar
Date: 6/13/2017, 6:33 PM
To: A10-Me-Earthlink



        Most people that have NC Mill's need to pay for them. That increases
        the cost of the parts.

        Here is a version of the warp drive hub/prop-flange/combination. It
        weighs more but it can be built with just any old  lathe.

        Twelve 3/8" set point screws anchor it to the hollow prop shaft.

        Anybody have a big lathe that can turn 9 inch diameter? I can send
        you the round blanks. It would be nice if you had Rhino or Solid
        Works but not essential.

        I need a set front and back for the gear box prototype.

        BTW the best blade I have seen so far is the Sensenich. The secret to
        more HP is a wider blade.


        Paul Lamar


        I have a 16" lathe, but how would you guarantee 120 degree placement
        of the blade mounts? Even the slightest offset would cause
        significant vibration.

        That being said, if I turned it down a local shop here has an NC
        mill that could drill the blanks. Their costs are reasonable, $70 an
        hour.


        Kevin Alderman

        That is a good hourly rate for an NC shop. If you give me the name I
        will request some quotes.

        I have a rotary table.

        Here is a company that keeps a low profile but they have great
        prices on machine tools. http://www.shars.com/ down load the pdf
        catalog.

        In case you need a rotary table.


        Paul Lamar

        Kevin, you can clamp a degree wheel to the rear of the spindle, and
        index from there!

        Steve carlisle


       Steve, I know about the degree wheel, but the bolt holes aren't my concern. It's the prob blade holes. Just 1 degree off or not perfectly bored and I get to spend a day trying to balance it.

       Making it round and bolting it together is the easy part. I figured I could turn out the blanks and the local shop do the bores.

       Kevin Alderman

       Check with Sensenich on the shank dimensions and see if they are the same as
       the warp drive.

       You will have to static balance it in any case. You will need to make a short shaft to do
       this and two parallel bars to do it on. Static balance is sufficient as blade
       deflection out of plane will happen no matter what. The quality control
       on the blade is most important for dynamic balance.

       Paul Lamar


   Kevin, is not the 120 degrees the same on the face as the periphery ?

   Steve Carlisle

Two and three blade props need quite accurate blade separation angles for balance. More blades can be equally split on 360° or this can be modified. A four blade is normally 90° between blades but this could be modified for noise reduction. Example is two opposite blades could be positioned to give 80°, 100°, 80°and 100°separations. Balance is not affected. Six blade would be the same idea.
Five blade normally is spaced 72° apart. Some automotive cooling fans had five blades but two wer fairly close together and the other three slightly closer together but not as close as the two. This kept balance but helped noise reduction.

Dale Davies

        The Rotary Engine free News Letter. Powered by Linux. If you want
        off the list PLEASE let me know and I will remove  you. ACRE NL web
        site. http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
        Copyright 1998-2017 All world wide rights reserved.