Subject: Warp drive hub non NC mill version
From: paul lamar
Date: 6/13/2017, 6:37 PM
To: A10-Me-Earthlink



Most people that have NC Mill's need to pay for them. That increases
the cost of the parts.

Here is a version of the warp drive hub/prop-flange/combination. It
weighs more but it can be built with just any old  lathe.

Twelve 3/8" set point screws anchor it to the hollow prop shaft.

Anybody have a big lathe that can turn 9 inch diameter? I can send
you the round blanks. It would be nice if you had Rhino or Solid
Works but not essential.

I need a set front and back for the gear box prototype.

BTW the best blade I have seen so far is the Sensenich. The secret
to more HP is a wider blade.


Paul Lamar


I have a 16" lathe, but how would you guarantee 120 degree placement
of the blade mounts? Even the slightest offset would cause
significant vibration.

That being said, if I turned it down a local shop here has an NC mill
that could drill the blanks. Their costs are reasonable, $70 an
hour.


Kevin Alderman

That is a good hourly rate for an NC shop. If you give me the name I
will request some quotes.

I have a rotary table.

Here is a company that keeps a low profile but they have great prices
on machine tools. http://www.shars.com/ down load the pdf catalog.

In case you need a rotary table.


Paul Lamar

Kevin, you can clamp a degree wheel to the rear of the spindle, and
index from there!

Steve carlisle


Steve, I know about the degree wheel, but the bolt holes aren't my
concern. It's the prob blade holes. Just 1 degree off or not
perfectly bored and I get to spend a day trying to balance it.

Making it round and bolting it together is the easy part. I figured I
could turn out the blanks and the local shop do the bores.

Kevin Alderman

Check with Sensenich on the shank dimensions and see if they are the
same as the warp drive.

You will have to static balance it in any case. You will need to make
a short shaft to do this and two parallel bars to do it on. Static
balance is sufficient as blade deflection out of plane will happen no
matter what. The quality control on the blade is most important for
dynamic balance.

Paul Lamar


Kevin, is not the 120 degrees the same on the face as the periphery
?

Steve Carlisle


Yes, but to make this part you have to machine both pieces and then bolt them together. Easy enough. A dowel pin beside each blade will keep things aligned nicely. After bolt up, use the lathe to true it all up and it should be pretty well balanced at this point. So far we have turned all of this out on a lathe with the part in a rotating chuck.


Now to get the holes for the blades, you have to drill at a right angle to the face which is in the plane of rotation of the chuck. And, this hole has to be precisely aligned at 120 degrees, but be true in both axes to make sure 1. The blade tips are equidistant and 2. The tips operate in the same rotational plane i.e. tips track in the same plane. I suppose one could turn out the piece then move it to the tailstock end on a degree wheel and chuck the bit to drill the holes, but I figure for a reasonable cost I could make the blanks and have the NC mill do it precisely. I could get my 16 year old to turn out the blanks on my lathe and maybe make a couple of sets then take it a couple of miles down the road and it's done.

Kevin Alderman


The Rotary Engine free News Letter. Powered by Linux. If you want off
the list PLEASE let me know and I will remove  you.  ACRE NL web
site. http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
Copyright 1998-2017 All world wide rights reserved.