Subject: Next part in gear box the coupling.
From: paul lamar
Date: 6/14/2017, 9:28 PM
To: A10-Me-Earthlink



For the simple part NC machining  is kept down to a minimum
but if cost is no object then about a pound might be saved
by pocketing from the back slide. Right now the part bolted
to the e-shaft counter weight is 2.5 pounds.

The steel  input shaft to the gear box is 1.5 inch in diameter
and hollow. This has some machining and seal advantages.

This coupling is attached to the input shaft with extended point 1/4 inch
set screws. The greatest thing since sliced bread.

Silicon rubber cushion blocks can be cut with a band saw.

Kevin, please see how much your NC guy will charge.

Paul Lamar

Are the drawings you included dimensioned? Will save time.
I would take them by and show him what we are after.

Keven Alderman

Drawings these days are in IGES format. I will send those shortly.

Paul Lamar

The Rotary Engine free News Letter. Powered by Linux. If you want off
the list PLEASE let me know and I will remove  you.  ACRE NL web
site. http://www.rotaryeng.net You Tube http://tinyurl.com/beqqxas
Copyright 1998-2017 All world wide rights reserved.