Subject: Turbo Rx8 carb draw through style
From: paul lamar
Date: 6/16/2017, 1:43 PM
To: A10-Me-Earthlink



I hate to lower the level of intelligence here but is it ok to use a GT45 with a holley carb draw through style . The fuel itself would help cool things down wouldn't it?

Any intake manifold pressure relief would have to be exited to the outside of the cowl or perhaps back into the end of the exhaust  .
Wastegate alternative as described by you Paul could still be the same.

My other thought was towards the propeller. Is there a propeller that could take 350hp and be ground adjustable to soak up 650 hp at a latter date?

Hope I am not to far off the planet. Its all new stuff to me

Mark Dillner


 I built a 3 rotor version but so far I did not run it. So I have no experience.
Here are a few pictures. I'll sell the carb if you want to buy it.

Paul Lamar


The Rotary Engine free News Letter. Powered by Linux. If you want off
the list PLEASE let me know and I will remove  you.  ACRE NL web
site. http://www.rotaryeng.net <http://www.rotaryeng.net/>You Tube http://tinyurl.com/beqqxas
Copyright 1998-2017 All world wide rights reserved.